How To Make A Wood Lathe With A Drill Press

Insert first the nut and then the wood drive nut in the bolt.

How to make a wood lathe with a drill press. Put it in a vise and with the file make four points. Hello friendsThis time I will introduce how to make a wood lathe function of a 6in1 drill pressHow to make an amazing 6in1 drill system like never before P. If playback doesnt begin shortly try restarting your device.

This system will help us to adjust the distance depending on the piece we are going to work. A live center would be better but I didnt have any appropriate parts available. Ive seen many similar tutorials but they all make it way more complicated than it ne.

YouTube woodworker Nick Ferry used a set of nuts and bolts as his dead. The largest bolt I was going to tighten to the slot in my drill press table to act as a tool rest. Cut 3cm at the bottom of the tailstock and drill the center.

Then drill a hole that would snugly fit your bearing of about 14 inches deep. The result was very good since it. A jig to use the drill press as a lathe.

Start by making two holes on the plywood then cut through the holes to make a longer hole. Make a similar but small box as the mount for the drill. This wood lathe is made from plywood wood screws drill sander and glue.

Insert the drive-in nut in the chuck and tighten it. This jig holds the drill press drilling axis horizontal and gives makes the drill press stable while operating in a horizontal position. Much of this wood lathe is built using scrap plywood and he even made wood gears for this project.