How To Do Metal Stud Framing

Lay out the position of the track strike chalk lines and drill a hole through the metal and into the concrete the full length of the screw.

How to do metal stud framing. Tighten the gun fully then snip off the tip of the tube nozzle by a quarter-inch. Hand clamps and C-clamps are useful while metal snips a chop box or circular saw are needed for cutting. Fasten steel tracks to concrete using 1-14 in.

Learn from the best now. The primary fastener is a sheet metal screw. Prior to the installation of interior board high winds.

Make sure you leave it loose until the drywall goes up. Set screws first at each end of the metal framing track and then every 3 ft. A screw gun is the main tool for screwing studs to the tracks and other studs.

The proper way to handle an inside corner when you use metal stud framing is sliding that first sheet into the inside corner and fastening the last stud adjacent to the drywall. And wood framing is typically spaced at 16 OC. Insert a screwdriver shaft into the center of the nozzle hole to puncture the inner seal.

MORE on how to install a steel door frame. When framing a home the. Clients can expect to pay between 5 and 10 per square foot of the project or 10 30 per linear foot.

How Far Apart Do Metal Studs Need to Be. Leave the stud that butts into the other wall loose and run the drywall through first. It is always ideal to have a stud finder on you to do the job.