How To Wood Veneer Corners

Apply slightly oversized strips of 18-in-thick MDF to opposite edges of the birch plywood using cork-covered cauls to spread the pressure evenly.

How to wood veneer corners. Yes there is a backer on the veneer but quite frankly it shouldnt be that conspicuous. Another point is the paper backing is going to be about the same color as the veneer. To get a clean look on these Thibodeau veneers the edges first and then veneers the faces all the way to the edge.

You dont want a sharp or ragged edge exposed which may snag and splinter the veneer. Using hydraulic pressure for applying veneer is a reliable method but the presses can be time consuming and unwieldy to use. Two at a time.

Progressively fold those strips around the edge and tape into place allowing them to. Roll back the clock 100 years veneer was 18 or thick it could be mitered. Another option is to leave the hardwood edge a little proud about 030 and butt the veneer.

4 Center the selected pattern section over the substrate panel and apply the contact cement following the manufacturers instructions to both the veneer and the substrate. Lightliy sand the corner any gaps will be invisible. It is tricky - use plenty of glue but not so much that it opens your corner when folded should squeeze out the back and use blue tape so that the veneer doesnt peel out or fuzz up.

You need to position the veneer on an adhesive coated substrate a flat piece of wood used to help distribute the pressure evenly is placed on top of the veneer and the three are clamped together with hydraulic or mechanical veneer press clamps. The way I learned to do veneered corners is to cut a 1818 groove down the corner. The actual thickness is only 020.

Place your veneer at the edge of a bench or table with the line of your cut overhanging it slightly. Place your template over the desired section of veneer and cut out that portion leaving approximately one-half inch or 127 centimeters 05 in of excess on each side. Other than doing the veneer before you cut the miters like production factory that is what you get.