How To Turn Spindles On A Wood Lathe

One way is to use the headstock and the rear spindle to suspend a piece of wood between the two and turn along the length of the piece of wood.

How to turn spindles on a wood lathe. See more ideas about wood turning wood turning projects turn ons. The tenons were cut by mounting the blanks in the Spigot Jaws of the chuck and running the lathe at a very slow speed. Start at one end and remove the corners Photo 10a.

When turning spindles I like to cut a crosshatch into the ends of the turning blank so the workpiece centers quickly and seats solidly on the lathe. They then split that section of the trunk into usable sized billets in a process called riving A froe the edged tool with the wooden handle at right is used to rive wood. Unless curly the bole is clear wood because there are no emanating branches that cause a knot.

You should cut above center for most lathe tools. Adjust the height of the tool rest to match the tool you are using. Set the fingers to just drop through barely touching the.

When you put the turning blank on the lathe and the grain of the wood is parallel to the bed of the lathe then you are doing spindle turning. Nov 7 2018 - Explore Ray Browns board Spindle followed by 293 people on Pinterest. Once the rest of the spindle is turned simply move the steady a bit 6 is usually enough and turn the oversizeburned spot to size.

With the spindle and machine set up complete youre ready to cut woodUsing a spindle gouge and holding the chisel approximately parallel to the floor gently probe the tip of the chisel into the spinning spindle. Widen the groove to prevent the tool from grabbing. When the grain of the turning blank is at right angles to the lathe then you are doing faceplate or bowl turning.

Check your work by stopping the lathe to see if the spindle blank is round or by running the lathe and resting the back of the chisel on the blank. The roughing gouge is a very versatile gouge but it must be used. Turn out the middle with a small gouge leaving a flat-bottomed recess ¼ deep.