How To Prep Bare Wood For Paint

This goes beyond the paint job to include the actual paintings on the walls or that aesthetically pleasing living room and more.

How to prep bare wood for paint. Start with a low-grit sandpaper of around 60-grit or so to grind down sharper edges. You can do away with these imperfections easily using a handheld power sander. This is what wood conditioner is for.

Sandpaper or a sanding sponge to smooth out rough spots and dry spackling paste acrylic latex caulk and a caulk gun to fill gaps painters putty to fill small nail holes spackling paste or wood putty to fill large holes and gouges oil or alkyd-based undercoat primer. New timber should be sanded with medium to fine paper of about 120 grade. How to Prepare Exterior Wood for Painting.

To get a long lasting beautiful finish from your paint or varnish and to avoid flaking and chipping you will need to prepare your bare wood properly. New or bare timber will need to be primed after sanding if you are to paint it. Clean thoroughly with sugar soap sand down with a fine paper to give a key for the new paint and then apply your paint.

See before after pics httpwwwdisplays2. Then switch to a high-grit paper 100-grit or higher and smooth the paint down to the underlying wood. It there is paint already on the furniture then you will want to use a medium grit sandpaper to smooth down the wood and remove any paint that is chipping.

Home décor is important if a house is going to be made into more than just four walls and a roof. Be careful not to burn the wood. Before staining you want to make sure the woods pores are open which will allow for an even stain.

Dont attempt to strip lead paint sometimes found in old houses with a heat gun seek advice from a reputable painter and decorator. Priming Bare Wood. Next sand down the surface of your wood.