How To Make A Homemade Desktop Charger

Hello friends in this video i will show you how to make a 4-9 volt battery charging kit the things you need1.

How to make a homemade desktop charger. Read the instructions included with the USB charger and consult an electrician if you are not sure about any part of them. Strip the red and black wires. Avoid hot glue as this will leave lumps in your mouse pad.

Hi friends today I am going to show 12v Battery Charger With Old SMPS. You can simply use a pencil or a wooden skewer to make holes. The toggle switch and potentiometer are added in the front.

If you are using fabric use fabric glue or a spray adhesive for the best results. You can try to create a charging station using a shadowbox. Planter Box Charging Station.

Here I cut and remove all output wires without yellow black and greenThen I connect. NOW take the wire of 1 mm thickness and pass it through the hole made in the center this is extra bit of wire for electrical connections. It is big enough to put some phones once.

Besides some basic tools you only need plywood and a quartet of hairpin legs to pull it off. First of all cut a small circle of diameter 1 cm with a cardboard glue it to a piece of cardboard and make a hole in the center. And how to do it for under 75Here is a.

Make sure your wall box measures at least 3 x 2 x 25 2. I am NOT an electrician our install was very simple but your wiring may be different. Make four holes in the box in the desired positions to put the toggle switch pot adapter jack and the charging led.