Easy Ways To Use A Table Saw

Lower the blade guard and turn on the table saw.

Easy ways to use a table saw. There is an old saying in construction and woodworking. Conclusion Learning how to use a router table will make your woodworking projects easier and more convenient. Keep at least 6 inches between your hand and the saw blade.

One way to make the adjustment is by holding a ruler up to a piece of scrap wood. Measure twice cut once. Push the board through the blade at a slow and steady rate keeping the board flush with the fence.

Get out the mitre gauge for your table saw and lay the board flat on the table up against the mitre gauge. Turn on the saw and firmly hold the work piece to the miter gaugesled. Now that weve gotten the safety features discussed and handled lets move into the instructions for using a table saw.

Table saws have an adjustment crank that raises and lowers the blade from where it sits inside the table. You should avoid cutting deeper than ⅜ inches in one pass. Mark 14 in 064 cm then place it next to the saw.

Place it into a metal pan and cover it with water. Set the blade height line up you mark with the appropriate side of the blade remember table saw blades usually have an 18th kerf account for this. How to Make Tongue Groove with a Table Saw.

Use a wrench and undo the nut around the center of the blade by turning it counterclockwise and slide the blade out. Just like in the picture run the board over the blade so it takes off a portion of the board with each pass. When you get near the end of the board use a push stick to push the rest of the board through.